Constructor:Work modes for graded nest of pieces

From Julivi Help
Jump to: navigation, search

Modes for work with graded pieces

The program has an option to correct pieces separately in each size of a graded piece.

Operations with pieces, contours, sections and points are performed both with the whole graded piece and separate sizes. It refers to the functions of different shifts, deformations, rotations, etc.

However, the operations changing the structure of a piece (change of parameters and the number of contours, sections, points) are applicable to the whole graded piece in any mode.

The mode for work with graded pieces depends on the state of screen switches :

embim728.png  - work mode for one size: Operations are performed for one selected size.

embim729.png - work mode for several sizes: Operations are performed for a number of sizes.

On selection of the following mode, a window is displayed, where necessary sizes are selected:

  embim730.png

embim731.png - work mode for the whole graded piece: Operations with the pieces are performed for all sizes.

The button for the selected mode is marked with a “check mark”:embim732.png, embim733.png, embim734.png

ATTENTION! The operations changing the structure of the piece are applicable to the whole graded piece regardless of the switch position. This limitation prevents from creation of an incorrect graded piece.

However, in the window “Control of a graded piece” work with every size is allowed for all the active functions in order to be able to correct errors in graded pieces.


Example of work with one size of a graded piece

While checking conjugation of pieces you can correct line shape in any one size with incorrect configuration. To do so:

·        Create a group of superposed pieces on the screen Commands embim735.pngof the screen functions menu

·        View conjugation of the pieces in different sizes (buttons embim736.png of the lower panel)

·        Having found a size with an incorrect shape, switch on the mode for work in one size embim737.png

·        Correct the piece shape in a given size, for example, with the help of the functions from the SECTION tab:

embim738.png - “Section/ Arbitrary deformation and embim739.png - “Section/Spline deformation of section

 embim740.png
 

·        View conjugation for other sizes of a piece, correcting their shape size by size.

·        When inspection for conjugation is finished, switch to the general mode for work with graded pieces: embim741.png

Example of work with a partial graded piece

The function for equalization of dart sides equal can only be performed for some of the large sizes in a graded piece, if there is no front dart in smaller sizes. To do so:

·        Switch on the mode for work with a partial graded piece embim742.png, and select sizes for work in the table (in this example 108 and 112)

·        Make equal the distance at the dart sections (embim743.png - “Point/ Make equal the distance between the points)

·        Switch to the general mode for work with a graded piece:embim744.png

 
embim745.png