Constructor:Visibility of different piece elements on the screen

From Julivi Help
Jump to: navigation, search

 

Visibility of different piece elements on the screen

When there is a lot of visual information on the screen, it can be difficult to manage. The piece elements selected while performing the functions can overlap: one contour can match with another one, the points of different contours can get to the same place, etc. To solve such problems you can switch off visibility of certain contours, parameters, elements, etc.

The contour with switched off visibility will not be drawn while drawing on the printer or plotter.

The screen button menu has a row of buttons for visibility and sensitivity of piece elements:

embim986.png

All the types of piece contours are displayed on these buttons. Selection of the button with a contour image switches off its visibility. Another selection of the button switches it on again.

Deselection of a flag underneath the button allows to switch off sensitivity of a given contour type. The contour is visible on the screen, but is not available for any operations.

Meaning of the buttons for contour visibility:

embim987.png - Working cut embim988.png - Cut embim989.png- Ready view

embim990.png - Inner contour embim991.png - Marking point embim992.png - Grain line

embim993.png - Sight embim994.png - Text

embim995.png - Cut line embim996.png - Pinhole embim997.png - Shadow embim998.png - Contour cuttings

Apart from contours, you can switch off visibility for other piece elements on the screen:

embim999.png - points (except notches), embim1000.png - piece names, embim1001.png - parameters of seams and constructions (cuffs, vents)

 

There are two working modes for the visibility panel available, depending on the setting selection

(text menu points “Settings/ Piece parameters”, GENERAL/ Constructor tab)

  embim1002.png

1) In the mode for line visibility “Screen”, visibility is switched off for all the pieces on the screen at once, and the selected button of the bloc is highlighted, as if stuck.

2) In the mode for line visibility “Piece” the switch above the panel is activated:

embim1003.png - visibility/sensitivity commands are active for all the pieces on the screen

embim1004.png - visibility/sensitivity commands are active for one specified piece on the screen.

The selected buttons are not highlighted in this mode for visibility (as work with one piece is possible, which means that for some pieces the button must be highlighted, but not for the others).

ATTENTION! Do not forget to switch on visibility of the element again to continue working with it.

FEATURES The button embim1006.png switches off visibility of different types of contours, for which status “Cut” is switched on. The button does not have a sensitivity switch and is only applicable to the whole screen (even in the visibility mode “Piece”).