Constructor:Modes for shifting a section

From Julivi Help
Jump to: navigation, search

Modes for shifting a section

The section can be shifted with deformation of its two adjacent sections or without any deformation.

The shifting mode depends on the state of the switch for deformation of the adjacent sections:

Embim1800.png

YES button: shifting a section with deformation of the adjacent sections: the ends of the adjacent sections are shifted along with shift of the working section.

NO button: shifting a section without any deformation of the adjacent sections: the working section is moved separately, without affecting the adjacent sections. The breaks between the sections are automatically locked with two additional sections.

This switch has no sense when working with an unlocked contour.

Embim1801.png

Embim1802.png When working in the shifting mode “Without deformation” (with creation of two additional sections for locking the contour) it is important to remember the following: if set a zero shifting value in some sizes, the section will not be shifted in these sizes. It means that no additional sections will be created, and an INCORRECT GRADATION with a different number of sections will be created!!!