Constructor:Lines
Lines
For making different marks or auxiliary constructions you may often need to draw different types of lines (horizontal, vertical, straight, parallel, etc) on pieces.
These lines are drafted on the piece as inner contours with the help of the commands in the LINES tab or from the text menu "Contour/ Lines":
You can make the following constructions: Horizontal line, Vertical line, Normal and Tangent lines, Equidistant line, Segment of a set length and direction; Straight line between points; Quilting lines.
Straight lines
Straight line from a point
To create a straight line of a set type (horizontal, vertical, normal, tangent) from any point of the section:
You can also follow the text menu points "Contour/ Lines / Straight line from a point".
- Specify the point (1) or any place of the section. The window with the parameters of the straight line is displayed on the screen:
- Limitation for a straight line inside the contour, where a point is specified, is set by default
If necessary, you can select a different type of a limiting contour by means of switching on a necessary type of the switch “Limit”. It can be Cut, Finished view or any locked contour specified upon selection of a point: Inner or Working contour.
- Select the button of a necessary construction command with clicking it with the left mouse button:

