Difference between revisions of "Constructor:about-constructor"

From Julivi Help
Jump to: navigation, search
 
(4 intermediate revisions by the same user not shown)
Line 1: Line 1:
 
*[[Constructor:Launch of the program|Launch of the program "Constructor"]]
 
*[[Constructor:Launch of the program|Launch of the program "Constructor"]]
 
*[[Constructor:Special symbols and methods executing commands|Special symbols and methods executing commands]]
 
*[[Constructor:Special symbols and methods executing commands|Special symbols and methods executing commands]]
 +
 +
 +
 +
== Program «Constructor» is a component of the software system «JULIVI». ==
 +
It allows to solve all construction tasks for piece development. To be more precise:
 +
* design using the following operations: cut, conic and parallel spread, growth, construction of collars and cuffs, opening, closing and transfer of darts, joining pieces or sections, free drawing, etc.;
 +
* any piece modifications (construction of cuts, seams, cusps, dart design, etc.);
 +
* technical grading of pieces (gradation);
 +
* interface control on the plane (screen superposition and rotations of pieces);
 +
* digitization of paper pieces and spreads with the help of digitizer;
 +
* reconstruction of chain of related pieces after changes in reference data;
 +
* work with data in the format '''GERBER, LECTRA, ACCUMARK, NOVOCUT, ASSYST, MICRODYNAMICS, CYBRID, INVESTRONICA,''' etc., as well as with data of DXF standard.
 +
  
 
[[Category:Constructor]]
 
[[Category:Constructor]]

Latest revision as of 10:23, 5 February 2015


Program «Constructor» is a component of the software system «JULIVI».

It allows to solve all construction tasks for piece development. To be more precise:

  • design using the following operations: cut, conic and parallel spread, growth, construction of collars and cuffs, opening, closing and transfer of darts, joining pieces or sections, free drawing, etc.;
  • any piece modifications (construction of cuts, seams, cusps, dart design, etc.);
  • technical grading of pieces (gradation);
  • interface control on the plane (screen superposition and rotations of pieces);
  • digitization of paper pieces and spreads with the help of digitizer;
  • reconstruction of chain of related pieces after changes in reference data;
  • work with data in the format GERBER, LECTRA, ACCUMARK, NOVOCUT, ASSYST, MICRODYNAMICS, CYBRID, INVESTRONICA, etc., as well as with data of DXF standard.