Difference between revisions of "Constructor:about-constructor"
From Julivi Help
(Created page with "== Launch of the program "Constructor" == == Special symbols and methods executing commands ==") |
|||
| (7 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | *[[Constructor:Launch of the program|Launch of the program "Constructor"]] | |
| − | + | *[[Constructor:Special symbols and methods executing commands|Special symbols and methods executing commands]] | |
| + | |||
| + | |||
| + | |||
| + | == Program «Constructor» is a component of the software system «JULIVI». == | ||
| + | It allows to solve all construction tasks for piece development. To be more precise: | ||
| + | * design using the following operations: cut, conic and parallel spread, growth, construction of collars and cuffs, opening, closing and transfer of darts, joining pieces or sections, free drawing, etc.; | ||
| + | * any piece modifications (construction of cuts, seams, cusps, dart design, etc.); | ||
| + | * technical grading of pieces (gradation); | ||
| + | * interface control on the plane (screen superposition and rotations of pieces); | ||
| + | * digitization of paper pieces and spreads with the help of digitizer; | ||
| + | * reconstruction of chain of related pieces after changes in reference data; | ||
| + | * work with data in the format '''GERBER, LECTRA, ACCUMARK, NOVOCUT, ASSYST, MICRODYNAMICS, CYBRID, INVESTRONICA,''' etc., as well as with data of DXF standard. | ||
| + | |||
| + | |||
| + | [[Category:Constructor]] | ||
Latest revision as of 10:23, 5 February 2015
Program «Constructor» is a component of the software system «JULIVI».
It allows to solve all construction tasks for piece development. To be more precise:
- design using the following operations: cut, conic and parallel spread, growth, construction of collars and cuffs, opening, closing and transfer of darts, joining pieces or sections, free drawing, etc.;
- any piece modifications (construction of cuts, seams, cusps, dart design, etc.);
- technical grading of pieces (gradation);
- interface control on the plane (screen superposition and rotations of pieces);
- digitization of paper pieces and spreads with the help of digitizer;
- reconstruction of chain of related pieces after changes in reference data;
- work with data in the format GERBER, LECTRA, ACCUMARK, NOVOCUT, ASSYST, MICRODYNAMICS, CYBRID, INVESTRONICA, etc., as well as with data of DXF standard.